Toro ProPass 200 Operator's Manual page 16

A hydraulic flow control valve controls the speed of
the option (Twin Spinner). The spinner icon indicates
the speed percentage for the wireless controller
only—for standard hydraulics, place the control in the
appropriate color area, starting at the dotted line and
adjust speeds within the color zone as required.
On/Off Pendant
Model 44701 Only
Use the 2 switches on the On/Off pendant to run the
conveyor belt or the option
On/Off pendant within reach of the operator.
1. On/off pendant
E-Stop Button
Model 44751 Only
When finished working with the machine, always
press the E-S button
TOP
electrical system. When beginning work with the
machine you must pull the E-S
before turning on the handheld remote.
(Figure 23). Keep the
Figure 23
(Figure 24) to disable the
button back out
TOP
1. E-S Button
TOP
g013346
Diagnostic LED Function
After pulling up the E-S
LED (Figure 25) will illuminate and remain on for 5
seconds, turn off for 5 seconds, and then will begin
flashing at 3 Hz (3 flashes a second) until you turn the
handheld remote on. If the light turns on for 5 seconds
and then starts blinking at 10 Hz (with or without a 5
second pause), there is a fault with the machine; refer
to Checking Fault Codes (EH Models Only) (page
Note:
If you had the handheld remote on when you
pulled up the E-S
at 3 Hz (3 flashes per second) after turning off for 5
seconds.
1. Diagnostic LED
16
Figure 24
button, the diagnostic
TOP
button, the light will not flash
TOP
Figure 25
g237530
43).
g237532