Installing The Fixed Plate Kit (Optional) - Toro Reelmaster 3100-D Series Operator's Manual

Figure 6
1. O-ring
2. Counterweight
2. On right end of cutting unit, remove the plastic plug
from the bearing housing
3. Remove the 2 bolts from the right side plate
2
Figure 7
1. Plastic plug
4. Install the counterweight to the right end of the cutting
unit with the 2 cap screws previously removed.
5. Loosely install the 2 reel-motor mounting bolts to the
left plate of the cutting unit
3. Cap screw
(Figure 7).
(Figure
1
G003321
2. Bolts (2)
(Figure 7).
5
Installing the Fixed Plate Kit
(Optional)
Parts needed for this procedure:
1 Fixed plate kit (not included)
Procedure
1. Remove the nuts and washers securing the lift links to
the cutting-unit side plate and carrier frame
7).
1. Nuts
2. Using the number 2 holes, insert a fixed plate onto the
bolts and secure it with the nuts removed.
Note: The number 1 holes are to be positioned toward
the front. Do not reuse the washers.
Note: The number 1 hole is a less aggressive setting
and the number 3 hole is a more aggressive setting.
6
(Figure
Figure 8
2. Washers
9).