Using A Preset Mode; Choosing A Tow Vehicle; Loading The Hopper; Unloading The Hopper - Toro ProPass 200 Operator's Manual

then
The screen will display PRESET SAVED.
Note:
If you hold the S
P button while either the floor or option are off,
RESET
no new value is stored for either floor or option; the
preset holds the values previously stored.

Using a Preset Mode

1. Press the desired P
display the floor and option settings.
2. Press the A S
LL TART
option (if the hydraulics are turned on).
3. Use the S and S
TART
floor and option as desired

Choosing a Tow Vehicle

WARNING
Always use a suitable tow vehicle to move
the machine, even for short distances. An
unsuitable tow vehicle can damage the
machine, or cause injury or death.
The override access is on the driver side of
the hydraulic system. (see Figure 15)
A suitable tow vehicle must have a minimum towing
capacity of 1,405 kg (3,400 lb).
On tow-behind chassis the maximum carrying load
for the machine is 907 kg (2,000 lb), with a resulting
tongue weight of 113 kg (250 lb). The tare weight
(no load) is 499 kg (1,100 lb), with a resulting tongue
weight of 23 kg (50 lb).
The resulting tongue weight of the machine fitted with
the 11 hp Hydraulic Power Pack when operating with
a full load is 145 kg (320 lb). The resulting no load
tongue weight is 48 kg (105 lb). The tare weight (no
load) is 599 kg (1,320 lb).
On Truckster direct connect chassis the maximum
carrying load for the machine is 2,000 lb (907 kg),
with a resulting weight transfer of 272 kg (600 lb) to
the tow vehicle. The tare weight (no load) is 544 kg
(1,200 lb), with a resulting weight transfer of 52 kg
(115 lb) to the tow vehicle.
, , or
button and press a
TORE
button (1, 2 or 3) to
RESET
button to start the floor and
buttons to control the
TOP

Loading the Hopper

WARNING
Ensure that the machine is connected to the
tow vehicle before loading.
Do not carry loads that exceed the load limits of the
machine, or the tow vehicle; refer to
(page 17).
The stability of loads can vary—for example, high
loads will have a higher center of gravity. Reduce
the maximum load limits to ensure better stability, if
necessary.
To avoid causing the machine to tip over (see safety
decals in this manual):
•
Carefully monitor the height and weight of the
load. Higher and heavier loads can increase the
risk of tipping.
•
Distribute the load evenly, front to back and side
to side.
•
Be careful when turning and avoid unsafe
manoeuvres.
Important:
Do not put large or heavy objects
into the hopper. Material that is larger than the
rear gate opening may damage the belt and
rear gate assembly. Also ensure that the load
has a uniform texture. Small rocks in sand can
become projectiles.
WARNING
Do not carry passengers in the hopper.

Unloading the Hopper

WARNING
The machine is capable of amputating hands
and feet.
Keep hands and feet away from the hopper
guard on the spinner guard and the spinner
assembly when the machine is operating or
when the hydraulic power pack engine, on the
tow vehicle, is running.
Do not stand behind the machine when unloading or
spreading. The Twin Spinner ejects particles and dust
at a high speed.
Do not unload the machine while it is on a slope.
34
Specifications