Possible Optipoint Adapter Configurations - Siemens HiPath 3000 Series Service Documentation

wclient.fm
Workpoint Clients
optiPoint 500
10.5.3.6

Possible optiPoint Adapter Configurations

Adapter categories
Each U port in the system provides two B channels. This means that you can connect two
P0/E
telephones, each with a separate phone number, to one U
Category 1 optiPoint 500 adapters
The following adapters each require a B channel and, therefore, can only be used once on a
host terminal (host terminal requires the second B channel of the
U port).
P0/E
optiPoint analog adapter
●
optiPoint ISDN adapter
●
optiPoint phone adapter
●
If one of these adapters is used in the optiPoint 500 advance, only a category 2 adapter can be
operated in the second slot.
Category 2 optiPoint 500 adapters
The following adapters can be used on the host and client telephones. This is also true if a cat-
egory 1 optiPoint 500 adapter is already connected.
optiPoint acoustic adapter
●
optiPoint recorder adapter
●
Configuration restrictions
The voltage feed test can be used to check whether a
>
essary for an adapter configuration. To avoid any doubts, the test should always be
implemented when installing large configurations.
Number of usable adapters and key modules
HiPath 3000/5000 shows the maximum number of adapters and key modules that can be con-
nected to Section 10.5.5. The limits also include the client telephones connected over optiPoint
phone adapters and the analog telephones connected over optiPoint analog adapters.
10-104
Nur für den internen Gebrauch
port.
P0/E
local power supply
A31003-H3590-S100-7-7620, 06/2012
HiPath 3000/5000 V9, Service documentation
is also nec-