Setting The Transmission Rate Of A Specified Port (-S); Setting The Auto-Negotiation Mode Of A Specified Port (-An) - Huawei IN200 User Manual

Huawei IN200 NIC
User Guide
Port0 default auto-negotiation: on
Port0 default force speed: 25GE

6.1.4.23.2 Setting the Transmission Rate of a Specified Port (-s)

Function
The hilink_speed -s command is used to set the transmission rate of a specified port.
Format
hinicadm hilink_speed -i <devicename> -p <portid> -s <speed> [-d]
Parameters
Parameter
devicename
portid
speed
Usage Instruction
l
l
Example
# Set the transmission rate of port 0 to 25 GB and make the setting take effect permanently.
[root@localhost tool]# hinicadm hilink_speed -i hinic0 -p 0 -s 25 -d
Set forced speed succeed.
Set default configuration succeed.
Active default configuration succeed.

6.1.4.23.3 Setting the Auto-Negotiation Mode of a Specified Port (-an)

Function
The hilink_speed -an command is used to enable or disable the auto-negotiation mode of a
specified port.
Format
hinicadm hilink_speed -i <devicename> -p <portid> -an <state> [-d]
Issue 06 (2019-07-27)
Description
Indicates the name of the
IN200 to be configured in
the system.
Indicates the number of
the port to be set.
Indicates the port rate
when the auto-negotiation
mode is disabled. The unit
is GB.
If the command contains -d, the setting is permanent and takes effect after a restart.
If the command does not contain -d, the setting is not permanent and will be restored to
the factory setting after a restart.
Copyright © Huawei Technologies Co., Ltd.
Value
Example: hinic0 or hinic1
-
10 or 25
6 Management Tools
83