Huawei IN200 User Manual page 127

Huawei IN200 NIC
User Guide
Command
ip link set dev ethx vf <num> <rate
txrate>
ip link set dev ethx vf <num> state
<staus>
Table 6-5
For details about how to use the commands, see the help information provided on the CLI.
Table 6-5 Common vconfig commands
Command
vconfig add ethx <vlan_id>
vconfig rem <vlan-name>
Table 6-6
For details about how to use the commands, see the help information provided on the CLI.
Table 6-6 Common dcbtool commands
Command
dcbtool sc ethx dcb on/off
dcbtool gc ethx dcb
dcbtool gc ethx pg
dcbtool sc ethx pg pgid:xxx
dcbtool sc ethx pg pgpct:x,x,x,x,x,x,x,x
dcbtool sc ethx pg strict:xxxxxxxx
dcbtool sc ethx pg up2tc:xxxxxxxx
dcbtool gc ethx pfc
dcbtool sc ethx pfc pfcup:xxxxxxxx
Issue 06 (2019-07-27)
lists the common vconfig commands supported by the IN200 and their functions.
lists the common dcbtool commands supported by the IN200 and their functions.
Copyright © Huawei Technologies Co., Ltd.
Function
Sets the rate limit parameter of the virtual
network port.
Sets the link status of the virtual network port.
Function
Adds a VLAN sub-device.
Deletes a VLAN sub-device.
Function
Enables or disables Data Center Bridgin
(DCB).
Queries the DCB status.
Queries the priority group settings.
Specifies the priority bandwidth group to
which a specified priority is mapped.
Specifies the bandwidth ratio of each
priority bandwidth group (the sum is 100%).
Sets a specified priority to strict.
Specifies the TC group to which each
priority is mapped.
Queries the PFC status of each priority.
Specifies the PFC enablement status of each
priority.
6 Management Tools
118