Dimension Drawing; Assembly And Installation - ABB i-bus EIB Product Manual

®
ABB i-bus EIB / KNX
2.3

Dimension drawing

2.4

Assembly and installation

© 2006 ABB STOTZ-KONTAKT GmbH
Device technology
2CDC 072 051 F0006
Fig. 3: Dimension drawing
The Application Unit Time is a DIN rail mounted device for insertion in
distribution boards for snap-on mounting on 35mm mounting rails, in
accordance with DIN EN 60 715.
The connection to the bus is carried out via the bus connecting terminal
supplied.
The device is ready for operation once the bus voltage has been applied.
The accessibility of the devices for operation, testing, inspection,
maintenance and repair must be ensured (according to DIN VDE 0100-520).
Commissioning requirements
To put the Application Unit Time into operation, a PC with ETS3 and an
interface connection to the ABB i-bus
interface are required.
The device is ready for operation once the bus voltage has been applied.
The installation and commissioning may only be carried out by specialist
electricians. When planning and setting up electrical installations, the
relevant norms, guidelines, standards and specifications must be observed.
- Protect the device against damp, dirt and damage during transportation,
storage and operation.
- Only operate the device within the specified technical data!
- Only operate the device in an enclosed housing (distribution board)!
®
, e.g. via an RS232 interface or a USB
10