Display - ABB Navigator 500 Series Operating Instructions Manual

Navigator 500
Sodium analyzer

7.1.4 Display

Menu
Display
Select
Exit
Menu
Language
Operator Templates
Page 1 (to 5) Template Page 1 template cannot be set, this defaults to the number of
Chart View
Channel 1 (to 4)
Source
Tag
Chart Duration
View/Log Enables
50
Used to select the display language, setup Operator page templates (1 to 5), enable diagnostic,
view and log functions, set the device's display brightness / contrast and set the time and date.
Comment
Selects the display language:
English / German / French / Italian / Spanish.
Enables a template to be assigned to a wet-section for display
purposes – refer to Section 6.5, page 31 for Operator Template
examples.
wet-sections connected.
The chart can be configured to display the trend for 1, 2, 3 or 4 PV
and / or temperature values. The engineering ranges for the values
are configured in the Sensor Setup menu – see page 46.
Note: This menu is displayed only when Chart View is Enabled at the
Operator Functions / Chart View.
Selects the signal (PV and temperature) to be displayed on the chart.
A 3-character, alphanumeric tag used to identify the parameter on
the chart.
Selects the chart duration from 1, 2, 4, 8, 12, 16, 20 and 24 hours.
Enables / disables the following View and Log functions:
View functions:
Diagnostics View / Signals View / Chart View / Alarm View / Analog
OP View – refer to Section 6.6, page 33 for examples of Operator
Pages in View mode.
Log functions:
Calibration Log / Alarm Log / Audit Log / Diagnostics Log – refer to
Section 6.7, page 34 for examples of Operator Pages in Log mode.
7 Menu descriptions
Default
English
Page 1
Continued on next page...
OI/ASO550–EN Rev. G