Transmitter Operation Modes; Operator Menus - ABB Navigator 500 Series Operating Instructions Manual

Navigator 500
Sodium analyzer

6.2 Transmitter operation modes

The transmitter has 4 modes of operation – all modes are accessed from the Operator menu – see Fig. 6.2.

Operating – used to display real-time wet-section values on Operating Pages – refer to Section 6.5, page 31.

View – used to display diagnostic messages, alarms, output values, signals (including the flow rate where applicable) and (chart)
traces – refer to Section 6.6, page 33.

Log – used to display recorded (diagnostic, calibration, audit) events and alarms – refer to Section 6.7, page 34.

Configuration – used to configure the transmitter – refer to Section 7, page 42.

6.3 Operator menus

Note. Operator menus
cannot
Referring to Fig. 6.2, Operator menus
To select Operator sub-menus (indicated by the
Fig. 6.2 Operator menus
Operator menus comprise:

Operator Pages – displays the Operator Page for each available wet-section.

Data Views – displays enabled data views.

Logs – displays enabled Log views.

Alarm Acknowledge – acknowledges the active alarm displayed in the Alarms View.

Manual Hold – holds (freezes) the current outputs and alarms for the selected wet-section(s).
Note. Active values are still indicated on the display.

Autoscroll (enabled on Operator pages only) – displays Operator pages sequentially when multiple wet-sections are fitted.

Media Card – displays the status of the SD Card / USB stick (enabled only media module is fitted).

Enter Configuration – enabled on all pages – enters Configuration parameters via the Access Level – refer to Section 6.9.2,
page 39 for access levels and password security options.
CAL shortcut – initiates a calibration directly from an Operator Page, press the
opens the Calibrate page, bypassing the Configuration level menus.
30
be accessed directly from the Configuration level.
A
are accessed from any Operating, View or Log page by pressing the
arrow) press the
Autoscroll
Manual hold
In Configuration
Enter Configuration
A
B
6 Operation overview – transmitter
C
key .
CAL
C
C
key (below the CAL prompt). This shortcut
B
key .
OI/ASO550–EN Rev. G