Siemens SINUMERIK 840D sl Commissioning Manual page 66

7 Machine Data
7.2 Display machine data for ShopTurn
9810
MD number
Standard value: 0
Change becomes effective after: IMMEDIATELY
Data type: UBYTE
Significance:
9811
MD number
Standard value: 0
Change becomes effective after: IMMEDIATELY
Data type: UBYTE
Significance:
9812
MD number
Standard value: 0
Change becomes effective after: IMMEDIATELY
Data type: UBYTE
Significance:
9820
MD number
Standard value: 0
Change becomes effective after: IMMEDIATELY
Data type: DOUBLE
Significance:
9821
MD number
Standard value: 0
Change becomes effective after: IMMEDIATELY
Data type: DOUBLE
Significance:
9822
MD number
Standard value: 0
Change becomes effective after: IMMEDIATELY
Data type: BYTE
Significance:
7-66
$MM_ST_GEAR_STEPS_SPINDLE_MAIN
Number of gears on main spindle
Min. input limit: 0
Protection level: 3/4
This MD is used to stipulate the number of gear stages for the main spindle.
$MM_ST_GEAR_STEPS_SPINDLE_T OOL
Number of gears on tool spindle
Min. input limit: 0
Protection level: 3/4
This MD is used to stipulate the number of gear stages for the tool spindle.
$MM_ST_GEAR_STEPS_SPINDLE_SUB
Number of gears on counter–spindle
Min. input limit: 0
Protection level: 3/4
This MD is used to stipulate the number of gear stages for the counter–spindle.
$MM_ST_MAGN_GLASS_POS_1
Position of magnifying glass for measuring tool, 1st axis
Min. input limit: –
Protection level: 3/4
This MD is used to enter the X coordinate of the zoom–in function.
$MM_ST_MAGN_GLASS_POS2
Position of magnifying glass for measuring tool, 2nd axis
Min. input limit: –
Protection level: 3/4
This MD is used to enter the Z coordinate of the zoom–in function.
$MM_ST_DISPL_DIR_MAIN_SPIND_M3
Displayed direction of rotation for main spindle with M3
Min. input limit: 0
Protection level: 3/4
This MD is used to stipulate which direction of rotation of the main spindle is displayed for
M function M3 in the operator interface. The settings for the direction of rotation are as seen
looking from the inside out.
0 = Clockwise
1 = Counterclockwise
For more information please refer to the section on "Spindle control".
SINUMERIK 840D sl Commissioning Manual CNC: ShopTurn – 11/2006 Edition
Max. input limit: 5
Units: –
Valid as of software version
ShopTurn 6.1
Max. input limit: 5
Units: –
Valid as of software version
ShopTurn 6.1
Max. input limit: 5
Units: –
Valid as of software version
ShopTurn 6.1
Max. input limit: –
Units: mm
Valid as of software version
ShopTurn 6.1
Max. input limit: –
Units: mm
Valid as of software version
ShopTurn 6.1
Max. input limit: 1
Units: –
Valid as of software version
ShopTurn 6.1
© Siemens AG 2006 All Rights Reserved
11/2006