Siemens SINUMERIK 840D sl Commissioning Manual page 113

11/2006
© Siemens AG 2006 All Rights Reserved
SINUMERIK 840D sl Commissioning Manual CNC: ShopTurn – 11/2006 Edition
Next define the changes themselves:
S
Modify a specific column for all tools:
COLUMNx=CONTENTS_IDENTIFIER
COLUMN: Column command
x: Column number, 1 – 12
CONTENTS_IDENTIFIER: Parameter or property of tool
S
Modify a specific column for a specific tool:
TOOL_IDENTIFIER = x=CONTENTS_IDENTIFIER
TOOL_IDENTIFIER: Tool type
S
Define different columns for each tool:
TOOL_IDENTIFIER = CONTENTS_IDENTIFIER / CONTENTS_IDENTIFIER / ...
TOOL_IDENTIFIER = CONTENTS_IDENTIFIER / CONTENTS_IDENTIFIER / ...
...
The parameters or properties of a tool are listed one after the other by means of a
CONTENTS_IDENTIFIER and are separated from one another by a slash "/". If the
default setting is to be used for individual columns, you still need to insert a forward slash.
If, for example, you only want to modify the last few columns, specify the number (x) of
the first column you would like to modify and list the respective CONTENTS_IDENTIFIERs
for the subsequent columns.
TOOL_IDENTIFIER = x=CONTENTS_IDENTIFIER / CONTENTS_IDENTIFIER / ..
Note
Using the COLUMN command, you can first define one column identically for
all tools and then adapt it specifically for individual tools.
You can mark comments by means of a semicolon (;) symbol.
If errors occur during evaluation of the configuration file, refer to the
TO_INI_F.LOG file for a description of the error. With ShopTurn on NCU
(HMI embedded) the file is located in drive I: and with the PCU 50.3 n directory
F:\MMC0W32\TMP.
8 Tool Management
8.8 Configuring the operator interface
8-113