Siemens SINUMERIK 840D sl Commissioning Manual page 118

8 Tool Management
8.8 Configuring the operator interface
Magazine location
type
Example
OEM parameter
8-118
Table 8-5 PARAMETER_IDENTIFIER
PARAMETER_IDENTIFIER
TPC6
TPC7
TPC8
TPC9
TPC10
You can change the input field into a toggle field for the parameter "Magazine
location type". The following values are entered: You must define the values of
the toggle field in the section T_MAG_PLACE_TYPE, by assigning values to
cursor texts.
Value = Text–ID
Valid Text–IDs and information on defining texts are provided in Chapter 8.8.7
"Defining texts").
[T_MAG_PLACE_TYPE]
DEFAULT = 89891
1 = 89868
2 = 89869
5 = 89872
9 = 89876
In this example, in the column "location type" you can select the values 1, 2, 5
or 9 using the "alternative" softkeys. Here, the values have been randomly se-
lected. Cursor texts that have been saved are displayed for the selected values.
If the actual value of the parameter devices from the configured values, then the
text, saved as DEFAULT, is displayed as cursor text.
You can change the input fields into toggle fields for the OEM tool parameters.
In so doing, specific values are entered.
You must define the values of the toggle field in Sections TPC1 ... TPC10, by
assigning cursor texts to the values (refer to Chapter 8.8.7 "Defining texts").
Also refer to the example on "Magazine location type" parameters.
You can define the width of the toggle field or the input field to a specific number
of characters. The standard width is 7 characters.
Further, for the input field, you can also specify the data type (integer or double),
however, only if you have not specified a toggle field. If you do not change the
data type, then, the double data type set as default, is used.
SINUMERIK 840D sl Commissioning Manual CNC: ShopTurn – 11/2006 Edition
Parameter
Parameter 6
Parameter 7
Parameter 8
Parameter 9
Parameter 10
© Siemens AG 2006 All Rights Reserved
11/2006