Siemens SINUMERIK 840D sl Commissioning Manual page 116

8 Tool Management
8.8 Configuring the operator interface
8-116
Table 8-4 CONTENT_ID
CONTENT_ID
Parameter
type *
T_SIZE_
LONG
W
T_MAG_
PLACE_TYPE
W
P_LOCKED M
MAG_T_
W
LOCKED
MAG_T_SIZE W
MAG_T_
W
FIXED
H_NBR S
TPC1 W
TPC2 W
TPC3 W
TPC4 W
TPC5 W
TPC6 W
TPC7 W
TPC8 W
TPC9 W
TPC10 W
* Parameter types: S = cutting edge data, W = tool data, M = magazine data.
Parameter "H number" will only be displayed if ShopTurn is set up for ISO dia-
lects (see section 11.4 "ISO Dialects").
SINUMERIK 840D sl Commissioning Manual CNC: ShopTurn – 11/2006 Edition
Parameter or property
Tool size
This parameter is not contained in the
ShopTurn
standard tool list.
Column header: LROU
Cursor text: Tool size
Input: Number of adjacent half locations
(maximum 7) to be blocked. The first half
location is always the magazine location in
which the tool is mounted. The number of
adjacent half locations is specified as a
four–digit number. The first digit is the
number of adjacent locations to the left,
the second to the right, the third above,
and the fourth below.
Requirement input: The tool must be lo-
cated outside a magazine.
Magazine location type
This parameter is not contained in the
ShopTurn standard tool list.
Column header: Location type
Cursor text: Magazine location type
Input: Number of magazine location type
Entry requirement: The tool must be lo-
cated outside a magazine.
Magazine location locked
Display only: Tool disabled
Display only: Oversized tool
Display only: Tool in fixed location
H number of an ISO dialect program
Parameter 1
Parameter 2
Parameter 3
Parameter 4
Parameter 5
Parameter 6
Parameter 7
Parameter 8
Parameter 9
Parameter 10
© Siemens AG 2006 All Rights Reserved
11/2006
Field
width in
number
of char-
acters
4
5
6
1
1
1
3
7
7
7
7
7
7
7
7
7
7