Siemens SINUMERIK 840D sl Commissioning Manual page 144

9 Additional Functions
9.5 Measuring cycle support in the G code editor
PCU 50.3
9-144
Requirements:
When HMI Advanced started up, the files AEDITOR.COM and STARTUP.COM
must have been stored in the STANDARD CYCLES (CST.DIR) directory.
when ShopTurn started up the archive ST_CYC.ARC must have been trans-
ferred from the PCU 50.3 to the NCK. The COMMON.COM file must have been
copied automatically to the STANDARD_CYCLES (CST.DIR) directory.
S
Copy the archive MCSUPP from the ARCHIVES\CYCLES–AR-
CHIVE\MCYC.
S
If you want to use the measurement result displays, you need to copy the
MCRESULT archive from the ARCHIVES\CYCLE_ARCHIVES\MCYC direc-
tory.
S
If the versions of the standard measuring cycles supplied with ShopTurn
(see file SIEMENSD.RTF or SIEMENSE.RTF on the software CD)
differ from the HMI Advanced measuring cycles (see AR-
CHIVES\CYCLE_ARCHIVES\MCYC\VERSION.ARC) in the first 4 digits
(e.g. 06.02), you need to copy the archive MCYCTURN from the
ARCHIVES\CYCLE_ARCHIVES\MCYC directory.
S
Remove the semicolon ";" preceding the following lines in file STAN-
DARD_CYCLES\COMMON.COM:
;sc8406=aeditor.com
;sc8407=aeditor.com;
Remove the semicolon ";" preceding the following lines in the file STAN-
DARD_CYCLES\AEDITOR.COM:
;HS15=($83531,,se1)
;PRESS(HS15)
; LS("F_mess","MZ_SKL.COM",1)
;END_PRESS
By doing this, you create the connection between the softkeys used to call the mea-
suring cycles support and the configuration file of the support screens.
S
In the file STANDARD_CYCLES\STARTUP.COM remove the semicolon ";"
preceding the following lines:
;HS15=($83070,,se1)
;PRESS(HS15)
; LS("Messz")
;END_PRESS
This allows you to modify the characteristics of the measuring cycle support
in the Startup operating area.
S
Restart the PCU 50.3.
S
If required, modify the characteristics for the measuring cycle support in the
"Startup" → ">" → "Measuring cycles" menu.
SINUMERIK 840D sl Commissioning Manual CNC: ShopTurn – 11/2006 Edition
;Measuring cycles for turning (horizontal softkey 6 on
;the expanded softkey menu in the
;G code editor)
;Measuring cycles for milling (horizontal softkey 7
;on the expanded softkey menu in the
;G code editor)
© Siemens AG 2006 All Rights Reserved
11/2006