Siemens SINUMERIK 840D sl Commissioning Manual page 151

11/2006
Supplementary
condition
© Siemens AG 2006 All Rights Reserved
SINUMERIK 840D sl Commissioning Manual CNC: ShopTurn – 11/2006 Edition
If the relevant mode of operation of the second tool carrier (with mirroring of the
X axis) is also to be used for G code programs, further settings must be made.
To activate mirroring when loading tools on the second tool carrier, the following
T replacement must be set:
10717 $MN_T_NO_FCT_CYCLE_NAME="F_T_REV2"
If the necessary mirror images are also to be activated automatically when pro-
gramming the TRASMIT command, this command must be replaced by a sub-
program (e.g., in the manufacturer directory):
10712 $MN_NC_USER_CODE_CONF_NAME_TAB[0]="TRANSMIT"
10712 $MN_NC_USER_CODE_CONF_NAME_TAB[1]="TRANSM"
TRANSMIT.SPF
PROC TRANSMIT(INT_NR)
F_T_REV2
TRANSM(_NR)
F_T_REV2
RET
Note
In the status display, TRANSM is now displayed instead of TRANSMIT.
The "Taper turning" option is not enabled when working with two tool carriers.
It is not possible to use the turning machine with B axis at the same time.
9 Additional Functions
9.8 Working with two tool carriers
J
9-151