Table of Contents
Advertisement
UP1500 User's Manual
password
pci_parity
pk*0_fast
pk*0_host_id
UP1500 800-A1
Sets or clears the SRM Console password stored in Non-Volatile RAM
(NVRAM).
The syntax is:
set password
The password is not an argument to the set password command; the SRM
Console prompts the user for the string, which must be between 15 and 30
characters.
Disables or enables parity checking on the PCI bus.
Some PCI devices do not implement PCI parity checking, and some have a parity-
generating scheme in which the parity is sometimes incorrect or is not fully
compliant with the PCI specification. A side effect of this aberrant behavior is that
superfluous PCI parity errors are reported by the host PCI bridge. In such cases,
the device can be used as long as parity is not checked; disabling PCI parity
checking prevents false parity errors that can cause system problems.
The syntax is:
set pci_parity value
The options for value are:
on
(default)
off
Enables fast SCSI to perform in either standard or fast mode. If the system has at
least one fast SCSI device, set the default controller speed to fast SCSI (1).
Devices on a controller that connects to both standard and fast SCSI devices will
perform at the appropriate rate for the device. If the system has no fast SCSI
devices, set the default controller speed to standard SCSI (0). If a fast SCSI device
is on a controller set to standard, it will perform in standard mode.
The syntax is:
set pk*0_fast scsi_speed
The options for scsi_speed are:
0
1
(default)
Sets the controller host bus node ID to a value between 0 and 7.
Enables PCI parity checking.
Disables PCI parity checking.
The controller is in standard SCSI mode.
The controller is in fast SCSI mode.
Chapter 4 Software Support
4-21
Advertisement
Table of Contents
