Samsung UP1500 800-A1 User Manual page 40

UP1500 User's Manual
show cpu
show device
UP1500 800-A1
5 FLOPPY
6 EIDE
7 PWR_MANAGEMENTEmbedded Yes
8 USB
The show cpu command displays the status of the CPU. The syntax is:
show cpu
Example 4-2 Show CPU Command
>>>show cpu
Primary CPU:
Active CPUs:
Configured CPUs:
SROM Revision:
The show device command displays status for devices and controllers in the
system: SCSI and MSCP(Mass Storage Control Protocol) devices, the internal
floppy drive, and the network. The syntax is:
show device [controller_name]
controller_name
Example 4-3 Show Device Command
>>>show device
dka600.6.0.8.0
dkb600.6.0.108.0
dqa0.0.0.16.0
dva0.0.0.0.0
pka0.7.0.8.0
pkb0.7.0.108.0
An example of a device name is dka200.2.0.7.1. Table 4-4 shows the
Embedded Yes 3f0
Embedded Yes 1f0
3f6
170
376
Embedded No
00
00
00
X1.7
The controller name or abbreviation. When
abbreviations or wildcards are used, all controllers
that match the type are displayed. If no name is
given, the display is a list of all devices and
controllers in the system.
DKA600 QUANTUM ATLAS IV 36 WLS
DKB600 QUANTUM ATLAS 10K 9WLS
DQA0 CD-ROM C DU4011
DVA0
PKA0 SCSI Bus ID 7
PKB0 SCSI Bus ID 7
Chapter 4 Software Support
6 2
14
15
UY0A
0A0A
UCH0
4-8