Panasonic LP-400 Series External Control Manual page 66

⿎ Control sample 1-2: Changing the marking characters for each marking
Remote mode ON
1. Laser pumping (ON)
2. Select file No.
3. Shutter setting (open)
4. Serial data input
5. Status request
6. Marking trigger
To finish the
marking
8. Shutter setting (close)
9. Laser pumping (OFF)
Remote mode OFF
Reference
• For using this command, set "serial data" of function characters at setting screen beforehand.
• When using this function (serial data), transmit this command by every marking. Otherwise it does not become marking
ready condition, and marking is not available.
• Only when the internal shutter is opened during the remote mode, the serial data can be transmitted to the laser marker.
• When transmit this command without any data, marking ready become ON, then nothing to be marked with serial data
input.
• For resetting the data, set the "reception mode ON" for command reception permission (MKM command) or close the
shutter.
66
LSR command
FNO command
SHT command
* Before sending SIN data, keep 20 sec. (LP-V series) or 15 sec. (LP-400 / LP-W series)
after turning ON the laser pumping, and 1 sec. after the opening shutter.
SIN command
STS command
"READY": ON
* "READY" will turn ON after the SIN command reception.
Yes
MRK command
Change the character.
"READY": OFF
7. Serial data input
SHT command
LSR command
Select the file in that Serial data marking function is set.
Send the character data to be marked.
Send STS command
again after a while.
No.
SIN command
ME-LP400V-EX-6