Panasonic LP-400 Series External Control Manual page 138

• Response to readout designation of power check result
STX PWR A
Data
Name length
[byte]
Current power 3
Power after
3
correction
Power
5
correction ratio
Correction
14
date
Total laser
9
radiation time
Reference
• Power correction refers to the function to correct not the max. laser power [W] value but the laser power setting value.
Power correction does not change the actual max. output power relative to initial power.
⿎ Error code : ECR
Reads out the error code of alarm or warning when an error has occurred.
• Readout request of error code
STX ECR R
• Response to error code readout
STX ECR A
Data length
Name
Error code
Error type
Reference
• Refer to "Error Indication" (P.151) for details on error codes.
138
[Current power] [Power after correction]
[Power correction ratio] [Correction date]
[Total laser radiation time]
32-byte
Content
"000"–"xxx"
"000"–"xxx"
"050.0"–"200.0" [%]
For 15:00:00 on April 1, 2012
"20120401150000"
"0000000.0"–"1000000.0" [h]
(Check sum) Delimiter
[Error code] [Error type]
5-byte
[byte]
"0000" : No error
4
"E001"–"E999" : Error codes
"0" : No error
"1" : Alarm (due to system abnormality)
1
"2" : Alarm (due to control or settings)
"3" : Warning
Indicates the current power ratio [%] in comparison with
the default laser power.
• The value obtained by multiplying the current power
by the power correction ratio is indicated.
It may differ from the calculated value depending on
the correction ratio.
• When the power correction has not been performed,
this value is "000".
When the power correction has not been performed,
this value is "000".
When the power correction has not been performed,
this value is "00000000000000".
(Check
Delimiter
sum)
Content
ME-LP400V-EX-6
(Check
Delimiter
sum)
Remarks
Remarks