Panasonic LP-400 Series External Control Manual page 124

Data
Name length
[byte]
Character
7
height
Character width 7
Center position
8
X
Center position
8
Y
Radius 8
Radius of line
7
interval
Start angle 7
Angle of
character 7
interval
Font No. 1
Bold line width 5
Laser power
3
correction
Scan speed
3
correction
(Laser
pulse cycle
correction) (3)
(Only for LP-V
series)
* For the detail of the model type, refer to "Target laser marker" (P.8).
Reference
• At marking of bold characters, set the values so ratio of character height to character width be within 1/4 to 4.
• Set the Bold Line Width to 1/4 or less of the character height or the character width, whichever is smaller.
124
Description
Model type* Setting range [mm]
LP-V10 "000.100"–"090.000"
LP-4x0 "000.100"–"110.000"
LP-4x5/LP-V15 "000.100"–"160.000"
LP-4x1/LP-W "000.100"–"055.000"
"-300.000"–"+300.000" [mm]
"+000.000"–"+300.000" [mm]
Model type* Setting range [mm]
LP-V10 "000.000"–"090.000"
LP-4x0 "000.000"–"110.000"
LP-4x5/LP-V15 "000.000"–"160.000"
LP-4x1/LP-W "000.000"–"055.000"
"-180.00"–"+180.00" [°]
"-180.00"–"+180.00" [°]
"1": character font 1
"2": character font 2
Model type* Setting range [mm]
LP-V10/LP-W "0.000"–"2.000"
LP-4x1/LP-V15 "0.000"–"4.000"
LP-4x0/LP-4x5 "0.000"–"6.000"
"000"–"200" [%]
"005"–"500" [%]
"050"–"200" [%]
ME-LP400V-EX-6
Remarks
The center coordinate for arc is indicated.
The difference of radius from the center position
of marking position to the next line is indicated
when the character string is marked over two or
more lines.
The angle from the positive (+) side of X
coordinate with counter-clockwise at the first
character in character string for marking is
indicated.
The angle between the center of character and
the center of next character is indicated.
The number corresponding to the 2 fonts
previously registered is indicated.
• The correction ratio is calculated using the
value set at the laser setting as 100%.
• With LP-400/LP-W series, nothing should be
input in Laser Pulse Cycle Correction.