Model Type* Setting Range [Mm]; Lp-4X0 "000.010"-"055.000 - Panasonic LP-400 Series External Control Manual

⿎ General condition : ALC
Sets the conditions related to whole file.
• Setting / Readout data of general condition
Sub
STX ALC
command
Sub command is "S" at the time of setting and "A" for response data at the time of readout.
• Readout request of general condition
STX ALC R
Data length
Name
[byte]
X offset
Y offset
Rotation offset
Overwriting
frequency
Overwriting
interval
Mirror (Y axis
symmetry)
Flip (X axis
symmetry)
Kerning
(1)
(omissible)
* For the detail of the model type, refer to "Target laser marker" (P.8).
Reference
• When marking on the flying object is valid, Overwriting Function cannot be used.
120
[X offset] [Y offset] [Rotation offset]
[Overwriting frequency] [Overwriting interval]
[Mirror (Y axis symmetry)] [Flip (X axis symmetry)]
(Check sum) Delimiter
Description
Model type*
8
LP-V10
LP-4x0
LP-4x5/LP-V15
8
LP-4x1/LP-W
7 "-180.00"–"+180.00" [°]
2 "01"–"99" [times]
3 "0.0"–"9.9" [sec.] or "010"–"060" [sec.]
"0": inversion OFF
1
"1": inversion ON
"0": inversion OFF
1
"1": inversion ON
"1": Level 1:
Minimize the origin point of the
character interval with this condition.
The character width such as "i" and "l"
(small letter "L") is recognized as "0".
"2": Level 2:
Set the origin point of the character
with intermediate degree between the
character interval set with Level 1 and
Level 3. The character interval such as
"i" and "l" (small letter "L") becomes 1/4
(fourth) of character width.
"3": Level 3:
Maximize the origin point of the
character interval with this condition.
The character width such as "i" and "l"
(small letter "L") becomes 1/2 (half) of
character width.
[Kerning]
Max. 31-byte
Setting range [mm]
"-045.000"–"+045.000"
"-055.000"–"+055.000"
"-080.000"–"+080.000"
"-027.500"–"+027.500"
ME-LP400V-EX-6
(Check
Delimiter
sum)
Remarks
Marking is repeated by the repeat
number set. When the marking on the
flying object is valid, set "01".
The interval period at overwriting
marking is set.
The character marked is inverted to the
Y axis.
The character marked is inverted to the
X axis.
Specifies the balance of the character
interval when "Proportional" is set
to "Marking Shape" on the "Marking
Condition".