Samsung DCS-816 Programming Manual page 206

SAMSUNG
DCS-816
MMC: 726
DESCRIPTION:
Provides a flexible means of setting in–band signalling for voice mail or auto
attendant parameters. There are eight main options for programming and
several sub–options to customise the application. Simple YES/NO, numeric
and alpha characters are required for setting VM/AA.
The following options may be selected for VM/AA operation:
0. EXT FOR DN1
1. TRK FOR DN1
2. EXT FOR DN2
3. TRK FOR DN2
4. SEPARATOR
5. DISCONNECT SIGNAL This signal is sent when the calling station or C.O.
6. CALL TYPE ID
0. DIRECT CALL
1. ALL FWD CALL
2. BSY FWD CALL
3. NOA FWD CALL
VM/AA OPTIONS
DTMF information for the station that called the
VM/AA port station that is forwarded to VM/AA
port.
DTMF information for the trunk that called the
VM/AA port.
DTMF information for the station that originated
the call to a station that is forwarded to a VM/AA
port.
DTMF information for the trunk that called a
station forwarded to a VM/AA port.
In cases where DN2 is used, this specific digit is
sent between the DN1 and the DN2 information.
Both DN1 and DN2 must be set to YES for
SEPARATOR to be sent.
line hangs up.
Under this VM/AA option are several customising
applications:
A call originating directly from another station in
the system.
This indicates that a call was forwarded to the
VM/AA port from a station with CALL FORWARD
ALL set.
This indicates that a call was forwarded to the
VM/AA port from a station with CALL FORWARD
BUSY set.
This indicates that a call was forwarded to the
VM/AA port from a station with CALL FORWARD
NO ANSWER set.
MMC 726 (Page 1 of 4)
Programming
February, 1999