Samsung DCS-816 Programming Manual page 199

SAMSUNG
DCS-816
MMC: 724
DESCRIPTION:
Provides the access codes and dialling plan needed for operation of features
and programs. The system comes with a wide range of acceptable numbering
plans set as default and the option to customise the dialling plan. An error
message is also provided in case an access/feature code is duplicated.
The following options may be selected:
0 STN DIAL NUMBER
1 TRK DIAL NUMBER
2 AA DIAL NO
3 MISC DIAL NUMBER Determines the miscellaneous port dialling
4 STNG DIAL NUMBER Determines the station group dialling numbers.
5 TRKG DIAL NUMBER Determines the trunk group dialling numbers.
6 FEAT DIAL NUMBER Determines the feature codes.
7 S0 STN DIAL NO.
Feature codes are entered via the dial keypad, by pressing numbers as shown
in the table below. For example, for OHVA, the number 6 would be pressed
three times. If Block Code is required, press 2 twice for the first letter B and
then use the UP or DOWN key to make the selection from BARGE to BLOCK.
Important: Remember that this program is system wide.
DIAL KEYPAD
PROGRAM KEYS
UP & DOWN
KEYPAD
SOFT KEYS
SPK
HOLD
COUNT
DIAL 2 AAPLAY
DIAL 3 DICT
DIAL 4 GPIK
DIAL 5
DIAL 6 MMPA
DIAL 7 PAGE
DIAL 8
DIAL 9 WCOS
DIAL NUMBERING PLAN
Determines the station port dialling numbers.
Determines the trunk port dialling numbers.
Determines the auto attendant port dialling
numbers.
numbers.
Determines the S0 station dialling number.
1
BARGE
DICT
HDSET
LCR LCR
NEW
REJECT
UA
WCOS
Used to scroll through options
Used to enter selections
Move cursor left and right
Used to store data and advance to next MMC
Used to clear previous entry
MMC 724 (Page 1 of 3)
2
CAMP
FAUTO
IOG
LCR
OHVA
SETMG
UA VMSCMT
WCOS
Programming
February, 1999
3