Panel And Interface Led; Interface Cable - Huawei Quidway Eudemon 200 Installation Manual

Installation Manual
Quidway Eudemon 200 Firewall
Table 7-10 Interface attributes of 4T1
Attribute
Connector
Connector number
Interface standard
Interface speed
Cable
Operating mode
Supported network
protocol
Supported service
Supported protocol

7.7.3 Panel and Interface LED

Table 7-11 illustrates the 4T1 panels and LEDs description.
Table 7-11 4T1 panels and LEDs description
Name
4T1
Category
LINK
ACT

7.7.4 Interface Cable

Interface cable (T1 cables) for T1-F is 100-ohm straight-through shielded cables, as
shown in Figure 7-6.
RJ-45
4
G.703/T1 102, G.704
1.544Mbps
T1 cable (100-ohm standard shielded cable)
FT1, CT1, PRI
IP
Novell IPX
Backup
Terminal access service
PPP
MP
Flash state and description
OFF means the link is not connected and ON means the link is connected.
OFF means no data is being transceived on the interface and blinking means data is being
transceived.
Description
Panel figure
7-15
Chapter 7 Interface Module