Table of Contents
Advertisement
Installation Manual
Quidway Eudemon 200 Firewall
IV. Decompress Application
If the application files read into the SDRAM pass the checking, they will be
decompressed. And the terminal screen displays the following information:
Begin Decompressing ..............................................
.................................................
Packet Decompress is completed !
Booting...
V. Initialize the system
After decompression, the BootROM program ends and the depressed application will
be executed. The terminal screen displays the following information:
Booting...
root begin...
Begin to start the system, please waiting ......
line Con 0 is available.
Press ENTER to get started.
The above information indicates the system initialization is done and the Eudemon200
operates normally. You can press <Enter> to enter the command-line configuration
interface and start configuring the Eudemon200. After you press <Enter>, the terminal
screen displays the following information:
<Eudemon>
4.2 Configuration Fundamentals
4.2.1 Basic Configuration Procedure
In general, the configuration steps are as follows:
Step 1: Before configuring a Eudemon200 firewall, the networking requirements have
to be made specific and detail. They include networking purpose, the role of the
Eudemon200 firewall in the network, the division of subnets, the type of the WAN and
transmission medium, the network security policy and reliability.
Step 2: Based on the above requirements, draw a clear and detail networking diagram.
Step 3: Configure the interface parameters of the Eudemon200 firewall. Firstly,
configure the physical operating parameters (such as synchronous/asynchronous
serial interface, baud rate and synchronous clock) of the interface according to the
transmission medium of the WAN. Secondly, configure the link layer protocol
Chapter 4 Boot and Configuration
4-7
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
