1Fe/2Fe; Introduction; Interface Attributes - Huawei Quidway Eudemon 200 Installation Manual

Installation Manual
Quidway Eudemon 200 Firewall
In the event that an interface module is not working normally, locate the problem by
performing the following operations.
Check the interface cables, making sure that you have used the correct cables.
View the LEDs on the interface module panel, ensuring that the interface module
is working normally.
Executing the configured display command, ensuring that the interface has
accepted the configuration and is working normally.

7.4 1FE/2FE

7.4.1 Introduction

The FE (Fast Ethernet) interface cards, 1FE and 2FE, available for Eudemon200 are
primarily used for the communications between the Eudemon200 and LAN(s).
Following are the differences between 1FE and 2FE.
1FE provides one 10/100Mbps RJ-45 Ethernet interface.
2FE provides two 10/100Mbps RJ-45 Ethernet interfaces.
The FE cards support:
The transmission distance of 100 meters if the category-5 twisted pairs are used.
The operation at the speeds of 100Mbps and 10Mbps, and auto-sensing.
Full duplex and half-duplex, with the former one in common use.

7.4.2 Interface Attributes

Table 7-2 1FE/2FE interface attributes
Connector
Connector number
Cable
Operating mode
Supported frame format
Supported network
protocol
Attribute
RJ-45
1
Standard Ethernet cable
Full duplex/Half-duplex
10M/100Mbps auto-sensing
Ethernet_II
Ethernet_SNAP
IP
Description
1FE
2
7-3
Chapter 7 Interface Module
2FE