Command Line Interface - Huawei Quidway Eudemon 200 Installation Manual

Installation Manual
Quidway Eudemon 200 Firewall
encapsulated on the interface and the related operating parameters according to the
type of the WAN.
Step 4: Configure the IP addresses or IPX network number of all the interfaces of the
Eudemon200 firewall according to the division of the subnets.
Step 5: Configure the routes. If it is necessary to enable the dynamic routing protocol,
configure the related operating parameters of the protocol.
Step 6: If there is any special security requirement, perform the security configuration
for the Eudemon200 firewall.
Step 7: If there is any special reliability requirement, perform the reliability configuration
for the Eudemon200 firewall.
Refer to Quidway Eudemon 200 Firewall Operation Manual for detailed introduction of
the protocols or function configuration the Eudemon200.

4.2.2 Command Line Interface

I. Characteristics of the command line interface
The command line interfaces provided by Quidway Eudemon200 firewall include a
series of configuration commands, through which a user can configure and manage the
Eudemon200 firewall. The command line interface has the following features:
Performs the local configuration through Console port.
Performs the local or remote configuration through the Telnet command, which
can be used to directly log on and manage other Eudemon200 firewalls.
Users can enter <?> at any time to get online help.
Provide prompt and help information for user's convenience.
Provide network diagnostic tools, such as Tracert and Ping, to quickly diagnose
the availability of the network.
Provide all kinds of detailed debugging information to diagnose network faults.
The command line interpreter adopts fuzzy search for the keywords of the
command. Any conflict-free keyword will be interpreted. For example, for the
display command, you can just enter <dis>.
II. Command line interface
Command line interface of Eudemon200 firewall provides a rich set of configuration
commands, which are grouped in system view. A group corresponds to a view (see
Operation Manual for details). You can switch between different views through
commands. Normally, only some specific commands can be executed in a certain view,
although some common commands (such as ping, display current-configuration,
and interface) can be used in every view.
Chapter 4 Boot and Configuration
4-8