Startup Process - Huawei Quidway Eudemon 200 Installation Manual

Installation Manual
Quidway Eudemon 200 Firewall
II. Power on the Eudemon200
Turn on the power switch of the Eudemon200 firewall.
III. Check/Operate after power-on
After powering on the Eudemon200 firewall, check
1) Whether the LEDs on the front panel are normal.
For the meaning of indicators under normal operation, see the description in Section
1.4 Introduction to General Modules.
2) Whether the information displayed on configuration terminal is normal.
For the local configuration, the booting interface displays on the configuration terminal
after the Eudemon200 firewall is powered on (refer to "Section 4.1.3 Startup Process" in
this manual).
When booting or power-on self-test (POST) is done, press <Enter>. After the command
line prompts <Eudemon>, you can start configuration.

4.1.3 Startup Process

I. Self-test on SDRAM
During the process of powering on the Eudemon200 firewall or resetting the
Eudemon200, the configuration terminal yields the following output first:
Do you want to go on checking sdram? Yes or not(Y/N)
This information asks if you want to check the SDRAM. If you press <N>, the system
will skip the SDRAM checking.
Note:
SDRAM checking is the responsibility of testing personnel and consumes a lot of time. Generally, it is
skipped. Normally, it takes 8 seconds to check 32M memory, so on and so forth. (About 2 seconds) After
the prompt appears, press <y> to start SDRAM checking. If the SDRAM is normal, the system yields the
following output:
test SDRAM...OK
If you press no key during 5 seconds after that, the system responds the default setting (N/n) and exits
from SDRAM self-test.
Chapter 4 Boot and Configuration
4-5