Preparing The Power Units - Siemens SIMATIC S5 Manual

The following switch setting must always be made at switch S1:
>
d =
Fig, 7/3 Setting at switch S1
The following jumpers must always be inserted:
x 14 x 15
1 2 3 1 2 3 1 2 3 1 2 3
Fig. 7/4 Jumper settings
If all the jumpers are correctly set, the IP247 can be inserted in the programmable controller.
Make sure that the power supply to the programmable controller is switched off.
7.1.5.3

Preparing the Power Units

The signal lines must be connected to the inputs of the power units as explained in the manual
and according to the instructions of the power unit manufacturer.
Module
Connector X4, X5, X6
Pin 1 Reset signal
Pin 2 Inverse reset signal
Pin 3 Clock pulse
Pin 4 Inverse clock pulse
Pin 5 Direction signal
Pin 6
Inverse direction signal
Pin 7
24 V for BB contact
Pin 8 Input for
ready signal
Pin 9
Ground
6 5 4 3
,
ADB 10 . . .
X 16 x 17 X 18
1 2 3
Color code
blue 1 ring
red 1 ring
grey 1 ring
yellow 1 ring
green 1 ring
brown 1 ring
white
black 1 ring
blue 2 rings
2 1 Jumpers
. 15
x x
10
1 2 3 1 2 3
Power
Planning
Xl 4 / 2-3
X15 / 1-2
X16 / 2-3
Xl 7/2-3
Xl 8/2-3
x 12 I x 13
1 2 3 1 2 3
unit 1 2 3
7-11
,