5.3.3.2
Programmers with two Floppy Disk Drives (PG675, PG635)
Start the PG by turning on the power or using the keyswitch
>
A > DSKMAINT <CR>
New diskette in drive A:
< F 5 > < F 1 > Y CF8>
>
— —
>
>
5.3.4
System Configuration
5,3.4.1
Programmers without a Hard Disk (PG675)
To work with COM247 effectively, it is advisable to create a system diskette on which all the re
quired programs are available, i.e. programs from the software package "PCP/M" should be
copied to one diskette:
Start the PG by turning on the power or using the keyswitch
A> DSKMAINT <CR>
New diskette in drive B:
< F 5 > <F3> Y <F8> <F8>
A> PIP <CR>
ZEFU diskette"3 of n" in drive A:
*B:=S5 WX204X.CMD[RV]
*<CR>
This diskette now contains the operating system "PCP/M" and all the S5-DOS programs you re-
quire to work with COM247, If this system diskette is correct, you should make it read-only by
placing a protective tab over the notch, since you should only read from this diskette when work-
ing with COM247. To avoid having to repeat this operation if the diskette is damaged or lost, you
should make a further copy of this diskette and keep it in a safe place.
<CR>
<CR>
<CR>
<CR>
<CR>
<CR>
<CR>
<CR>
<CR>
Getting Staried
5 - 7