Canon FINISHER-C1 Service Manual page 57

4. Last Sheet
When the last sheet has been put into order, the finisher controller PCB turns on the alignment
motor (M3) to move the alignment plate to the alignment position (to butt the plate against the
stack). Then, the finisher controller PCB rotates the delivery motor (M2) counterclockwise to move
down the swing guide.
The finisher controller PCB moves the stapler according to the staple mode selected on the
copier for stapling.
When stapling operation ends, the finisher controller PCB drives the alignment motor, and
moves the alignment plate to a point 10 mm behind the trailing edge of the paper. Thereafter, it
rotates the delivery motor (M2) clockwise to delivery the stack to the tray.
COPYRIGHT © 1998 CANON INC. FINISHER-C1/SADDLE FINISHER-C2 REV. 0 DEC. 1998 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 2 FINISHER UNIT BASIC OPERATION
Figure 2-230
2-27