Canon FINISHER-C1 Service Manual page 157

3. Removing the Paper Retaining
Plate
1) Remove the four screws, and detach the
PCB cover.
2) Remove the six screws, and detach the fold-
ing roller knob and the lower front cover.
3) Disconnect the 13 connectors [2], and four
screws [3]; then, detach the saddle stitcher
controller PCB [1].
4) Free the harness [5] from the cord clamp.
5) Force the screws into the two screw holes
in the paper retaining plate until they stop.
These screws will laser serve as a reference
when determining the distance L for mount-
ing the paper retaining plate. (Use the
screws used to hold the PCB covers.)
COPYRIGHT © 1998 CANON INC. FINISHER-C1/SADDLE FINISHER-C2 REV. 0 DEC. 1998 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 4 MECHANICAL CONSTRUCTION
[4] [5] [3] [2] [1] [2]
[3]
Figure 4-122B
L
Figure 4-123B
[2]
[3]
[3]
[2]
4-27