Canon FINISHER-C1 Service Manual page 142

CHAPTER 4 MECHANICAL CONSTRUCTION
3. Removing the Buffer Roller
Assembly
1) Remove the rear cover.
2) Disconnect the cable coming from the
buffer roller assembly inside the harness
guide assembly from the connector [1].
3) While pushing the side plates on both edges
of the buffer roller unit, free the notches [2]
on both edges from holes to remove the
buffer assembly [3].
4-12
COPYRIGHT © 1998 CANON INC. FINISHER-C1/SADDLE FINISHER-C2 REV. 0 DEC. 1998 PRINTED IN JAPAN (IMPRIME AU JAPON)
Figure 4-211A
[2]
[3]
Figure 4-212A
[2]
Figure 4-213A
[1]