Canon FINISHER-C1 Service Manual page 166

CHAPTER 4 MECHANICAL CONSTRUCTION
8. Removing the No. 1 and No. 2
Paper Deflecting Plates
1) Remove the four screws, and remove the
saddle stitcher unit rear cover.
2) Remove the two tension springs [1], and re-
lease the inlet guide plate [2].
3) Remove the claw [3] of the reflecting plate
bushing, and pull out the deflecting plate
shaft [4] toward the rear.
4) After detaching the front shaft of the paper
deflecting plate from the front side plate,
remove the paper deflecting plate [5].
4-36 COPYRIGHT © 1998 CANON INC. FINISHER-C1/SADDLE FINISHER-C2 REV. 0 DEC. 1998 PRINTED IN JAPAN (IMPRIME AU JAPON)
[2]
[1]
Figure 4-142B
[3]
Figure 4-143B
1
Figure 4-144B
[2]
[1]
[4]
[5]
2