Canon FINISHER-C1 Service Manual page 163

6. Adjusting the Stitcher Position
1) Remove the front inside cover.
2) Remove the front lower door.
3) Pull out the stitcher unit to the front.
4) Remove the three screws [2], and remove
the stitcher mount unit cover [1].
5) Remove the stitcher positioning tool [3]
from the back of the cover.
6) If you must adjust the front stitcher, remove
the center guide plate [5] and the front guide
plate [4] (1 screw each). If you must adjust
the rear stitcher, remove the center guide
plate [5] and the rear guide plate [6] (1 screw
each).
COPYRIGHT © 1998 CANON INC. FINISHER-C1/SADDLE FINISHER-C2 REV. 0 DEC. 1998 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 4 MECHANICAL CONSTRUCTION
Figure 4-134B
Figure 4-135B
[6] [5]
Figure 4-136B
[ 1 ]
[ 2 ]
[ 3 ]
[4]
4-33