Actual Signals And Parameters; What This Chapter Contains; Terms And Abbreviations; Default Parameter Values With Different Macros - ABB ACS150 User Manual

Actual signals and parameters

What this chapter contains

The chapter describes the actual signals and parameters.

Terms and abbreviations

Term
Actual signal
Def
Parameter

Default parameter values with different macros

When application macro is changed
the parameter values to their default values. The following table includes the
parameter default values for different macros. For other parameters, the default
values are the same for all macros (see section
Index Name/Selection
1001 EXT1 COMMANDS 2 = DI1,2
1002 EXT2 COMMANDS 0 = NOT SEL
1102 EXT1/EXT2 SEL
1103 REF1 SELECT
1106 REF2 SELECT
1201 CONST SPEED SEL 9 = DI3,4
1301 MINIMUM AI1
2201 ACC/DEC 1/2 SEL
9902 APPLIC MACRO
Definition
Signal measured or calculated by the drive. Can be monitored by the user.
No user setting possible. Groups 01...04 contain actual signals.
Parameter default value
A user-adjustable operation instruction of the drive. Groups 10...99 contain
parameters.
ABB STANDARD 3-WIRE
4 = DI1P,2P,3 9 = DI1F,2R
0 = NOT SEL 0 = NOT SEL
0 = EXT1 0 = EXT1
1 = AI1 1 = AI1
2 = POT 2 = POT
10 = DI4,5
0% 0%
5 = DI5 0 = NOT SEL 5 = DI5
1 = ABB STANDARD 2 = 3-WIRE
(9902 APPLIC MACRO), the software updates
Actual signals
ALTERNATE MOTOR POT
2 = DI1,2
0 = NOT SEL
0 = EXT1 0 = EXT1
1 = AI1 12 = DI3U,4D(NC) 1 = AI1
2 = POT 1 = AI1
9 = DI3,4 5 = DI5
0% 0%
0 = NOT SEL
3 = ALTERNATE 4 = MOTOR POT
Actual signals and parameters
65
on page 70).
HAND/AUTO
2 = DI1,2
21 = DI5,4
3 = DI3
2 = POT
0 = NOT SEL
20%
0 = NOT SEL
5 = HAND/AUTO