Installation And Commissioning Flowchart - ABB ACS150 User Manual

14

Installation and commissioning flowchart

Identify the frame size of your drive: R0...R2.
Plan the installation: select the cables, etc.
Check the ambient conditions, ratings and required
cooling air flow.
Unpack and check the drive.
If the drive will be connected to an IT (ungrounded) or
corner grounded system, check that the internal EMC
filter is not connected.
Install the drive on a wall or in a cabinet.
Route the cables.
Check the insulation of the input cable and the motor
and the motor cable.
Connect the power cables.
Connect the control cables.
Check the installation.
Commission the drive.
About the manual
Task See
Technical data: Ratings on page
Planning electrical installation
Technical data on page 113
Mechanical installation: Unpacking the drive
page 19
Hardware description: Type code
Electrical installation: Connecting the power
cables on page 32
Mechanical installation on page
Planning electrical installation:
cables on page 29
Electrical installation: Checking the insulation of
the assembly on page 31
Electrical installation: Connecting the power
cables on page 32
Electrical installation: Connecting the control
cables on page 34
Installation checklist on page
Start-up and control with I/O
113
on page 23
on
on page 17
19
Routing the
37
on page 39