Ce Marking; Compliance With The Emc Directive; Compliance With En 61800-3 (2004); C-Tick Marking - ABB ACS150 User Manual

122

Applicable standards

• IEC/EN 61800-5-1 (2003)
• IEC/EN 60204-1 (1997) +
Amendment A1 (1999)
• IEC/EN 61800-3 (2004)
• UL 508C

CE marking

See the type designation label for the valid markings of your drive.
A CE mark is attached to the drive to verify that the drive follows the provisions of the European Low
Voltage and EMC Directives (Directive 73/23/EEC, as amended by 93/68/EEC, and Directive 89/336/
EEC, as amended by 93/68/EEC).

Compliance with the EMC Directive

The EMC Directive defines the requirements for immunity and emissions of electrical equipment used
within the European Union. The EMC product standard [EN 61800-3 (2004)] covers requirements
stated for drives.

Compliance with EN 61800-3 (2004)

See page 124.

C-Tick marking

See the type designation label for the valid markings of your drive.
C-Tick marking is required in Australia and New Zealand. A C-Tick mark is attached to the drive to
verify compliance with the relevant standard (IEC 61800-3 (2004) – Adjustable speed electrical power
drive systems – Part 3: EMC product standard including specific test methods), mandated by the Trans-
Tasman Electromagnetic Compatibility Scheme.
The Trans-Tasman Electromagnetic Compatibility Scheme (EMCS) was introduced by the Australian
Communication Authority (ACA) and the Radio Spectrum Management Group (RSM) of the New
Zealand Ministry of Economic Development (NZMED) in November 2001. The aim of the scheme is to
protect the radio frequency spectrum by introducing technical limits for emission from electrical/
electronic products.

Compliance with IEC 61800-3 (2004)

See page 124.

RoHS marking

See the type designation label for the valid markings of your drive.
The RoHS mark is attached to the drive to verify that drive follows the provisions of the European RoHS
directive. RoHS = the restriction of the use of hazardous substances in electrical and electronic
equipment.
Technical data
The drive complies with the following standards:
Electrical, thermal and functional safety requirements for adjustable frequency a.c. power
drives
Safety of machinery. Electrical equipment of machines. Part 1: General requirements.
Provisions for compliance: The final assembler of the machine is responsible for installing
- an emergency-stop device
- a supply disconnecting device.
Adjustable speed electrical power drive systems. Part 3: EMC requirements and specific
test methods
UL Standard for Safety, Power Conversion Equipment, third edition.