Ce Marking; Compliance With The European Low Voltage Directive; Compliance With The European Emc Directive; Compliance With The European Machinery Directive - ABB ACS800 Series Hardware Manual

126

Applicable standards

• EN 50178:1997
• EN 60204-1:2006/ AC:2010 Safety of machinery. Electrical equipment of machines. Part 1: General requirements.
• EN 60529:1991
+ corrigendum May 1993
+ A1:2000
• EN 60664-1:2007
• EN 61800-3:2004
• EN 61800-5-1:2007
• UL 508C
• NEMA 250-2003
• CSA C22.2 No. 14-05

CE marking

A CE mark is attached to the drive to verify that the unit follows the provisions of the
European Low Voltage and EMC Directives. The CE marking also verifies that the
drive, in regard to its safety functions (such as Safe torque off), conforms with the
Machinery Directive as a safety component.

Compliance with the European Low Voltage Directive

The compliance with the European Low Voltage Directive has been verified
according to standards EN 60204-1 and EN 61800-5-1.

Compliance with the European EMC Directive

The EMC Directive defines the requirements for immunity and emissions of electrical
equipment used within the European Union. The EMC product standard
(EN 61800-3:2004) covers requirements stated for drives. See section
with EN 61800-3:2004

Compliance with the European Machinery Directive

The drive is an electronic product which is covered by the European Low Voltage
Directive. However, the drive can be equipped with the Safe torque off function and
other safety functions for machinery which, as safety components, are in the scope
of the Machinery Directive. These functions of the drive comply with European
harmonized standards such as EN 61800-5-2. The declaration of conformity for each
function is in the appropriate function-specific manual.
Technical data
The drive complies with the following standards.
Electronic equipment for use in power installations
Provisions for compliance: The final assembler of the machine is responsible for installing
- an emergency-stop device
- a supply disconnecting device.
Degrees of protection provided by enclosures (IP code)
Insulation coordination for equipment within low-voltage systems. Part 1: Principles,
requirements and tests.
Adjustable speed electrical power drive systems. Part 3: EMC requirements and specific
test methods
Adjustable speed electrical power drive systems - Part 5-1: Safety requirements -
Electrical, thermal and energy
UL Standard for Safety, Power Conversion Equipment, third edition
Enclosures for Electrical Equipment (1000 Volts Maximum)
Industrial control equipment
below.
Compliance