User-Programmable Self-Tests - GE N60 Instruction Manual

CHAPTER 5: SETTINGS
Table 5-15: Recommended settings for user-programmable LEDs
Setting Parameter
LED 1 operand SETTING GROUP ACT 1
LED 2 operand SETTING GROUP ACT 2
LED 3 operand SETTING GROUP ACT 3
LED 4 operand SETTING GROUP ACT 4
LED 5 operand SETTING GROUP ACT 5
LED 6 operand SETTING GROUP ACT 6
LED 7 operand Off
LED 8 operand Off
LED 9 operand BREAKER 1 OPEN
LED 10 operand BREAKER 1 CLOSED
LED 11 operand BREAKER 1 TROUBLE
LED 12 operand Off
See the figure in the Setting Groups section of the Control Elements section later in this chapter for an example of group
activation.

5.3.12 User-programmable self-tests

SETTINGS  PRODUCT SETUP  USER-PROGRAMMALBE SELF TESTS
 USER-PROGRAMMABLE
 SELF TESTS
All major self-test alarms are reported automatically with their corresponding FlexLogic operands, events, and targets.
Most of the minor alarms can be disabled if so wanted.
When in the Disabled mode, minor alarms do not assert a FlexLogic operand, write to the event recorder, or display target
messages. Moreover, they do not trigger the ANY MINOR ALARM or ANY SELF-TEST messages. When in Enabled mode,
minor alarms continue to function along with other major and minor alarms. See the Relay Self-tests section in chapter 7
for information on major and minor self-test alarms.
N60 NETWORK STABILITY AND SYNCHROPHASOR MEASUREMENT SYSTEM – INSTRUCTION MANUAL
Setting
LED 13 operand
LED 14 operand
LED 15 operand
LED 16 operand
LED 17 operand
LED 18 operand
LED 19 operand
LED 20 operand
LED 21 operand
LED 22 operand
LED 23 operand
LED 24 operand
DIRECT RING BREAK

FUNCTION: Enabled
DIRECT DEVICE OFF

FUNCTION: Enabled
RxGOOSE OFF

FUNCTION: Enabled
FIRST ETHERNET FAIL

FUNCTION: Disabled
SEC. ETHERNET FAIL

FUNCTION: Disabled
THIRD ETHERNET FAIL

FUNCTION: Disabled
SFP MODULE FAIL

FUNCTION: Disabled
BATTERY FAIL

FUNCTION: Enabled
SNTP FAIL

FUNCTION: Enabled
IRIG-B FAIL

FUNCTION: Enabled
PTP FAIL

FUNCTION: Enabled
Parameter
Off
BREAKER 2 OPEN
BREAKER 2 CLOSED
BREAKER 2 TROUBLE
SYNC 1 SYNC OP
SYNC 2 SYNC OP
Off
Off
Off
Off
Off
Off
Range: Disabled, Enabled. Valid for units equipped
with Direct Input/Output module.
Range: Disabled, Enabled. Valid for units equipped
with Direct Input/Output module.
Range: Disabled, Enabled
Range: Disabled, Enabled
Range: Disabled, Enabled
Range: Disabled, Enabled
Range: Disabled, Enabled
Range: Disabled, Enabled
Range: Disabled, Enabled
Range: Disabled, Enabled
Range: Disabled, Enabled
PRODUCT SETUP
5
5-107