GE N60 Instruction Manual page 350

FLEXLOGIC
SUMMATOR 1 HYSTERESIS
value, the
HYSTERESIS
"1.000" and the
SUMMATOR 1 HYSTERESIS
resultant output value falls below 0.970.
SUMMATOR 1 UNITS
SUMMATOR 1 PU BASE
N60 features, such as FlexElements. This value is used to normalize the
change it to a per-unit quantity). See the FlexElements section for details on per-unit base values.
SUMMATOR 1 INPUT1(6)
SUMMATOR 1 SCALE1(6)
evaluated.
SUMMATOR 1 POS1(6)
When the FlexLogic operand selected by this setting is activated (set to on), the summator uses the
multiplied by it's corresponding
SUMMATOR 1 EVENTS
on the rising edge of the
The summator logic shown is executed once in every power cycle.
5
5-190
— When the output value of the summator falls below the
FlexLogic operand is deactivated (set to off). For example, if the
SUMMATOR 1 OP
is "3.0%", then the
— Creates a character label for the summator output value display.
— Defines the per-unit base factor when using the
— These settings select the FlexAnalog quantity to use as a summator input.
— These settings apply a scale factor to their corresponding FlexAnalog input quantity as it is
— These settings determine if a selected input is used during an evaluation of the summation process.
SUMMATOR 1 SCALE
— This setting is used to generate events for the summator. The
FlexLogic operand.
SUMMATOR 1 OP
Figure 5-99: Summator logic
N60 NETWORK STABILITY AND SYNCHROPHASOR MEASUREMENT SYSTEM – INSTRUCTION MANUAL
FlexLogic operand is set to off when the
SUMMATOR 1 OP
SUMMATOR 1 OUTPUT
SUMMATOR 1 OUTPUT
setting and apply it to the resultant output.
CHAPTER 5: SETTINGS
SUMMATOR 1 PICKUP – SUMMATOR 1
SUMMATOR 1 PICKUP
FlexAnalog quantity in other
FlexAnalog quantity (that is,
SUMMATOR 1 INPUT
event is created
SUMMATOR 1 OPERATE
is
item