GE N60 Instruction Manual page 49
Network stability and synchrophasor measurement system
Hide thumbs
Also See for N60:
- Instruction manual (666 pages) ,
- Communications manual (532 pages) ,
- Instruction manual (602 pages)
Table of Contents
Advertisement
CHAPTER 3: INSTALLATION
PANEL CUTOUTS
The torque used to connect the terminal blocks to the back of the relay chassis (screws a, b, c shown) is 9 inch-pounds. For
the connections to the terminal blocks (rows 1 to 8), use a minimum of 17 inch-pounds. During manufacturing, the power
supply and CPU modules are installed in slots B and D of the chassis with 13 inch-pounds of torque on the screws at the
top and bottom of the modules.
3
N60 NETWORK STABILITY AND SYNCHROPHASOR MEASUREMENT SYSTEM – INSTRUCTION MANUAL
3-5
Advertisement
Table of Contents
