Lenovo ThinkStation P410 Hardware Maintenance Manual page 158

6. Position the flex module cover on the flex module. Ensure that the rail guides on the bottom of the
cover engage the rails on the flex module. Then, push the cover to the front of the flex module until
it snaps into position.
Figure 98. Reinstalling the flex module cover
7. Connect the card reader cable to the USB 2.0 connector on the system board. See "Parts on the
system board" on page 34.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 174.
Front Thunderbolt adapter kit
The front Thunderbolt adapter kit includes the following parts:
• A front Thunderbolt I/O adapter
• A front Thunderbolt PCI Express x4 card
• A bezel
• A GPIO cable
• A Mini-SAS cable
• An internal DP-to-DP cable
• Two external DP-to-DP cables
To install or replace a front Thunderbolt adapter kit, do the following:
1. Prepare your computer. See "Preparing your computer and removing the computer cover" on page 95.
2. Remove the flex module from the front of the computer. See "Optical drive" on page 111.
150
ThinkStation P410 Hardware Maintenance Manual