1. Prepare your computer. See "Preparing your computer and removing the computer cover" on page 95.
2. Locate the secondary hard disk drive. See "Computer components" on page 31.
3. Disconnect the signal cable and the power cable from the hard disk drive.
4. Pull the handle to release and remove the hard disk drive from the hard-disk-drive cage.
Figure 61. Removing the secondary hard disk drive
5. Flex the sides of the bracket to remove the hard disk drive from the bracket.
6. To install a new hard disk drive into the bracket, flex the bracket and align pin
4
pin
on the bracket with the corresponding holes in the hard disk drive. Do not touch the circuit
5
board
on the bottom of the hard disk drive.
Figure 62. Installing the hard disk drive into the bracket
1
, pin
.
Chapter 9
Installing or replacing hardware
2
, pin
3
, and
127