Card Reader - Lenovo ThinkStation P410 Hardware Maintenance Manual

What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 174.

Card reader

Attention: Before you replace any FRU, be sure to read and understand Chapter 1 "Read this first: Important
safety information" on page 1.
To replace the card reader, do the following:
1. Prepare your computer. See "Preparing your computer and removing the computer cover" on page 95.
2. Remove the front bezel. See "Front bezel" on page 97.
3. Locate the card reader. See "Computer components" on page 31.
4. Disconnect the card reader cable from the system board. See "Parts on the system board" on page 34.
5. Remove the front audio and USB assembly. See "Front audio and USB assembly" on page 139.
6. Remove the two screws that secure the card reader. Then carefully pull out the card reader from
the rear of the front audio and USB assembly.
Figure 80. Removing the card reader
140
ThinkStation P410 Hardware Maintenance Manual