5. Position the new cover presence switch so that the screw hole in the cover presence switch is aligned
with the corresponding hole in the chassis. Then install the screw to secure the cover presence
switch to the chassis.
Figure 55. Installing the cover presence switch
6. Connect the cover presence switch cable to the cover presence switch connector on the system board.
See "Parts on the system board" on page 34.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 174.
Power supply assembly
Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1.
Although there are no moving parts in your computer after the power cord has been disconnected, the
following warnings are required for your safety and proper Underwriters Laboratories (UL) certification.
CAUTION:
Hazardous moving parts. Keep fingers and other body parts away.
122
ThinkStation P410 Hardware Maintenance Manual