Internal Speaker - Lenovo ThinkStation P410 Hardware Maintenance Manual

7. Insert the cable of the new thermal sensor into the lower hole
tabs on the plastic holder holding the thermal sensor with the two holes
push the plastic holder until it snaps into position.
Figure 71. Installing the thermal sensor
8. Connect the thermal sensor cable to the thermal sensor connector on the system board. See "Parts on
the system board" on page 34.
9. Reinstall the front bezel. See "Front bezel" on page 97.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 174.

Internal speaker

Attention: Before you replace any FRU, be sure to read and understand Chapter 1 "Read this first: Important
safety information" on page 1.
Note: The internal speaker is only available on some models.
To replace the internal speaker, do the following:
1. Prepare your computer. See "Preparing your computer and removing the computer cover" on page 95.
2. Locate the internal speaker connector on the system board. See "Parts on the system board" on
page 34.
3. Disconnect the internal speaker cable from the internal speaker connector on the system board.
134
ThinkStation P410 Hardware Maintenance Manual
1 in the chassis. Then align the two
1 and 2 in the chassis, and