Lenovo ThinkStation P410 Hardware Maintenance Manual page 138

What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 174.
Replacing the solid-state drive
Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1.
To replace the solid-state drive, do the following:
1. Prepare your computer. See "Preparing your computer and removing the computer cover" on page 95.
2. Locate the desired storage drive bay. See "Internal drives" on page 35.
3. Disconnect the signal cable and power cable from the solid-state drive.
4. Remove the storage converter with the solid-state drive from the storage drive bay. See "Primary hard
disk drive" on page 125 or "Secondary hard disk drive" on page 126.
5. Flex the sides of the plastic 3.5-inch storage drive bracket to remove the storage converter from the
bracket.
Figure 66. Removing the storage converter from the 3.5-inch storage drive bracket
130
ThinkStation P410 Hardware Maintenance Manual