•
"Seven-segment display" on page 154
Slim optical drive
To install or replace a slim optical drive in the flex module, do the following:
1. Remove the flex module out of the chassis. See "Optical drive" on page 111.
2. Lift the clip on the rear of the flex module and slide the flex module cover to the rear to remove the cover.
Figure 82. Removing the flex module cover
3. If you are installing a new slim optical drive, press the two metal clips
the two screws as shown. Remove the two screws and then go to step 4.
Figure 83. Removing the plastic clip with the two screws
If you are replacing an old slim optical drive, do the following:
142
ThinkStation P410 Hardware Maintenance Manual
1
to remove the plastic clip with