7. Slide the new hard disk drive into the drive cage until it snaps into position.
Figure 63. Installing the secondary hard disk drive
8. Connect the signal cable and the power cable to the new hard disk drive.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 174.
Solid-state drive
The solid-state drive is only available on some models. This section provides the following instructions:
•
"Installing the solid-state drive" on page 128
•
"Replacing the solid-state drive" on page 130
Installing the solid-state drive
Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1.
To install the solid-state drive, do the following:
128
ThinkStation P410 Hardware Maintenance Manual